YEKA LEAKS - Liquid Rubber Sealer

• Interior and exterior use
• Galvanised and cement surfaces

• Highly flexible pure acrylic coating
• Water resistant
• Non-yellowing
• Excellent adhesion
• UV Resistant.
• Easy no-mess application
• Quick drying – 2 coats can be applied in one day
• Can be used as a base and topcoat
• Rust Inhibitor
• Can be used with woven or spun membrane
• Eco friendly
• Non-toxic
• Non-flammable
• Low VOC (EU Regulations)

• Mixing: Always stir well with a flat paddle before use
• Application Method: Brush, roller, or spray machine
• Thinning: Not recommended. This product is ready for use undiluted; but can be thinned with 8-10% water
• Cleaning: Clean equipment with water.

For Brush or Roller Application:

• Apply 3 coats of Yeka Leaks™ Liquid Rubber Sealer to achieve maximum penetration allowing 3 hours of drying time between coats, and an additional 4 hours in cold, wet weather
• Porous surfaces may require an additional coat to ensure the surface is properly coated

For Airless Spray Gun Application:

• Dilute with no more than 10% by volume with water
• Apply 3 coats of Yeka Leaks™ Liquid Rubber Sealer to achieve maximum penetration allowing 3 hours of drying time between coats, and an additional 4 hours in cold, wet weather
• Porous surfaces may require an additional coat to ensure the surface is properly coated

Steel & Galvanised Structures

• Remove all rust with a good quality rust remover, scrub, and rinse thoroughly with water
• Heavily rusted areas should be sandblasted to remove all existing paint and primed
• Remove dust, foreign material, grease, and oil with a degreaser
• Scrub with a hard broom or wire brush and wash off thoroughly with clean water
• Ensure that the surface is sound and dry before painting
• Apply 3 coats of Yeka Leaks™ Liquid Rubber Sealer to achieve maximum penetration allowing 3 hours of drying time between coats, and an additional 4 hours in cold, wet weather
• Porous surfaces may require an additional coat to ensure the surface is properly coated

Previously Painted Surfaces

• Ensure old paint coatings are firm and solid
• Remove all loose, flaking, and bubbling paint with a paint stripper, and rinse thoroughly with water
• Treat rusted areas with a good quality rust remover using a wire or hard bristle brush or broom. Rinse with water.
• Remove dust, oil, grease, and other foreign materials with a degreaser, rinse thoroughly, and allow to dry
• Ensure that the surface is sound and dry before painting
• Apply primer and leave to dry
• Apply 3 coats of Yeka Leaks™ Liquid Rubber Sealer to achieve maximum penetration allowing 3 hours of drying time between coats, and an additional 4 hours in cold, wet weather
• Porous surfaces may require an additional coat to ensure the surface is properly coated

Fibre-Cement, Cement Tiles, and Granular Tiles

• Remove all dust, dirt and loose granules, friable and powdery material with a high-pressure water jet or scrub down with a degreaser and a wire or hard bristle brush and water
• Prime with one coat bonding liquid and allow to dry for 2 hours
• Apply 3 coats of Yeka Leaks™ Liquid Rubber Sealer to achieve maximum penetration allowing 3 hours of drying time between coats, and an additional 4 hours in cold, wet weather
• Porous surfaces may require an additional coat to ensure the surface is properly coated

SPREADING RATE

• 2m² per 1l application on 100 microns per coat
• Coverage will depend on the porosity of the surface and application method

FINISH

• Semi-Gloss

Yeka Leaks™ cannot be held liable if the product fails due to improper surface preparation or application