• Suitable for all surfaces
• Interior and exterior use
• Galvanized and cement surfaces
• Wood surfaces
• Windows and many more …

• Highly flexible pure acrylic coating
• Water resistant
• Excellent adhesion
• UV resistant
• Easy no-mess application
• Quick drying - 2 coats can be applied in one day
• Clear drying – milky when wet
• Direct application – no primer needed
• Rust inhibitor
• Can be used as a base and top coat
• Eco friendly
• Non-toxic
• Non-flammable
• Low VOC (EU Regulations)

• Mixing: Always stir well before use with a flat paddle
• Application Method: Brush or roller
• Thinning: Not recommended, this product is ready for use
• Cleaning: Clean application equipment with water, do not allow the product to dry on the equipment

For Brush and Roller Application:

• Apply 2 coats to achieve maximum penetration
• Allow to dry for 60 – 90 minutes between coats depending on temperature
• Porous surfaces may require a third coat to ensure that the surface is well coated

Steel and Galvanized Structures

• Remove all rust with a good quality rust remover, scrub and rinse thoroughly with water
• Remove grease, oil, and other contaminants with a good quality de-greaser
• Ensure the surface is in good condition before application
• Apply 2 coats of Eco Advanced™ Invisible Rubber allowing 60 – 90 minutes drying time between coats depending on the temperature

Unpainted and Weathered Surfaces

• Ensure old paint coating is firm and solid
• Remove any loose or flaking and bubbling paint
• Treat rusted areas with a good quality rust remover and a wire or hard bristle brush or broom.Wash thoroughly with water and allow to dry before application
• Remove dust, oil, grease and any other foreign material with a good quality De-greaser.Wash thoroughly with water and allow to dry before application
• Ensure the surface is in good condition before application
• Apply 2 coats of Eco Advanced™ Invisible Rubber allowing 60 – 90 minutes drying time between coats depending on the temperature

Fibre-cement, Cement Tiles, and Granular Tiles

• Remove all dust, dirt and loose granules, friable and powdery material with a high-pressure water jet or scrub down with a hard bristle or wire brush and water
• Ensure that the surface is in good condition and dry before applying Eco Advanced Invisible Rubber
• Apply 2 coats of Eco Advanced Invisible Rubber allowing 60 – 90 minutes drying time between coats depending on the temperature

SPREADING RATE

• 4m² / l application n 100 microns per coat
• Coverage will depend on the porosity of the surface and application method

FINISH

• Semi-gloss (milky when wet and clear when dry)

Atlas Eco 1 (Pty) Ltd cannot be held liable if the product fails due to improper surface preparation or application.