Rust’s Worst Nightmare!
Tired of rust ruining your metal? Meet Eco Advanced WB QD Metal Paint, the quick-drying, UV-resistant, water-based coating your metal has been dreaming of! With a built-in flash rust inhibitor, this coating goes straight onto metal surfaces, giving them a smooth, long-lasting finish that stands up to the elements.
Whether it's for a quick touch-up or full coverage, this coating is here to protect your metal and keep it looking sharp!
Download the Technical Data Sheet (TDS) and Material Safety Data Sheet (MSDS) below
TDS  |
MSDS  |
COLOUR OPTIONS
APPLICATION AREAS
- Interior and exterior use
- Metals
PRODUCT FEATURES
- UV resistant
- Easy application
- Waterborne acrylic emulsion
- Quick drying
- Hard wearing
- Scratch resistant
- Can be used as a primer, base and final coat
- Rust inhibitor
- Stronger than QD enamels
- Eco friendly
- Non-toxic
- Non-flammable
- Low VOC (EU Regulations)
APPLICATION
- Mixing: Always stir well with a flat paddle before use
- Application Method: Brush, roller or spray application
- Thinning: Not recommended, this product is ready for use
- Cleaning: Clean equipment with water
For Brush or Roller Application:
- Apply 2 coats and allow to dry for 2 hours drying time between coats to achieve maximum penetration. Add 4 hours of drying time for application in cold weather.
- Apply a second coat to ensure that the surface is well coated
For Spray Application:
- Do not dilute – order product spray ready
- Apply 2 coats and allow for 2 hours drying time between coats to achieve maximum penetration. Add 4 hours of drying time for application in cold weather.
- Apply a second coat to ensure that the surface is properly coated
SURFACE PREPARATION
- Remove all rust with a good quality Rust Remover, scrub, and rinse thoroughly with water
- Heavily rusted areas should be sandblasted to remove all existing paint and primed using Metal Coat as a primer
- Remove dust, foreign material, grease, and oil with a heavy-duty degreaser
- Scrub with a hard broom or wire brush and wash off thoroughly with clean water
- Ensure that the surface is sound and dry before painting
- Apply 2 coats and allow 2 hours of drying time between coats to achieve maximum penetration. Add 4 hours of drying time for application in cold weather.
OTHER INFORMATION
SPREADING RATE
- 2-4m2per 1l application on 100 microns per coat
- Coverage will depend on the porosity of the surface and application method
FINISH
DISCLAIMER
Atlas Eco 1 (Pty) Ltd cannot be held liable if the product fails due to improper surface preparation or application.